Beauty

Low Humidity Control Cabinets – Want More Details..

Save maintenance and component charges by eliminating moisture in electrical cabinets Moisture in electrical cabinets, control panels and motor chambers can affect plant efficiency and product quality, leading to significant downtime and expensive repairs. This is especially critical in food processing industries, since moisture can lead to mold and bacterial growth and make regulatory concerns.

Save maintenance and component expenses through the elimination of moisture in electrical cabinets

Moisture in Dry Storage Cabinets, control panels and motor compartments can affect plant efficiency and product quality, leading to significant downtime and expensive repairs. This is particularly critical in food processing industries, since moisture can lead to mold and/or bacterial growth and make regulatory concerns. Purging the compartment with air dried by a system employing a filter and membrane provides a reliable solution with considerably lower initial and operating costs. The program can be utilized on the 24/7 basis even during washdown procedures (when drying is most needed).

Removing water vapor from air by way of a filter and a membrane

Water, compressor oils and particulate matter can be taken off compressed air (input temperature range =40-120oF as well as the input pressure range = 60-150 psig) utilizing a coalescing filter as well as a hollow membrane module. The coalescing filter removes water droplets, oil and particulate materials with the efficiency of 99.99% at .01 µm and also the hollow membrane fibers remove water vapor to offer dry air with a dew point of -7oF from saturated inlet air of 100oF and 100 psig.

Utilizing a cabinet dryer avoids downtime

Cabinet dryers have zero moving parts and require minimum maintenance; periodic replacing of a filter can be performed during routine system shutdowns. For example, a meat processing plant inside the Midwest that used a heater to maintain a control panel dry found which it was replacing the keypad every three weeks. After it replaced the heater having a cabinet dryer, it was easy to operate for half a year or even more at a time without any failures, replacing the filter over a routine maintenance basis.

A comparable cabinet drying system was installed on a metal detection system at Dan’s Prize, a division of Dry Cabinets For PCB Storage. Before the dryer was employed, it absolutely was necessary to stop production 3 x per week to eliminate moisture from your detector. According to Tom Breslin, Manager of Plant Engineering, “once we installed our dryer system, the issue went away. The dryer has been in place for regarding a year, with no maintenance issues.”

Dried compressed air reduces operating costs

The operating expense of a filter/membrane based system is considerably lower compared to alternative systems. For instance, Lee Clarkson, production engineer at Ross Industries in Midland VA, a manufacturer of meat tenderizers, food packaging equipment, and food processing systems, reports “essentially no operating costs for the membrane dryer once the system is installed, aside from annual cartridge replacement. Within the case from the meat processing plant discussed above, a saving of approximately $25,000/year was obtained from eliminating the requirement to replace the user interface and from down time through the replacement time.”

The Dehumidifying Dry Cabinets gives an effective, reliable and inexpensive strategy to the problem of mold or premature component failure due to moisture. The system fails to require electricity, has no moving parts and xakleh be utilized on a 24/7 basis, even during washdown procedures. The mixture of the coalescing filter as well as a membrane filter provides air using a dew point of -7oF along with a relative humidity of 10% or less, making sure cabinets will likely be kept bone dry.

Leave a Reply

Your email address will not be published. Required fields are marked *